Making Electrical Connections
Making electrical connections is a fairly common procedure but needs to be done correctly and carefully. If you don't
make tight connections, heat can build up between the conductors and cause a fire. Also make sure that the conductors you
are connecting are of like metals and the power is OFF. Use a tester to make sure that line is not live. Select the
appropriate gauge wire with the right casing for the job.
Items you will need:
Wire Nuts
Linesmans Pliers Wire Cable Ripper Stripper Electrical Tape
Step 1:
First a note about safety: Make SURE that you are
not working on live wires. If you are using cable that has a
non-metallic sheathing, use a cable stripper. Simply clamp the stripper
(Fig. 1) over the cable and pull it towards the end of the
cable (Fig. 2). Pull back the sheathing and expose the wires (Fig. 3).
Cut the sheathing off with a utility knife. Make sure
you examine the insulation on the wires to make sure the stripper didn't
tear it.
Step 2:
Expose about an inch of the bare wire by placing a wire stripper over the wire, clamp it over the wire (Fig. 4), twist it
once and then pull it towards the end of the wire. Repeat this for the other conductor. Pull the paper insulation from the
ground as well.
Step 3:
Put the conductors next to each other and put the exposed ends (Fig. 5) in the linesman's pliers.
Step 4:
Take a wire nut of an appropriate size and twist it over the end of the wire (Fig. 6) until the nut becomes difficult to turn.
|
|
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 |
Comments
Post a Comment